103. Overview - Arctic Spas

103. Overview

Owners Manual Bear Essentials Class
SPA SPECIFICATIONS
Outside Dimensions
Heights
Heater (Watts)
Water Capacity
Dry Weight
Electrical Requirements North America
Electrical Requirements Europe
93”x93” 235cm x 235cm
39” 99 cm
NA / Euro 4000 W
463 Gallons 1753 Litres
765 Lbs 347 Kg
240 Volt, 50 Amp
1 phase x 32Amp or 3 phase x 16Amp
In.ye Overview
Main Power Entry connection
Ground Input connection (European Version Shown)
Access to heater connections
Heat.way heater with in.flo technology
Accessible Bonding lugs
Industry- standard AMP connectors for outputs
Watertight strain relief system
Enough outputs for all your spa needs
Light outputs (i direct, 1 switched)
Main Keypad connector
Communications Link
Mounting feet”
“in.ye Dimensions
Front View
Side View
Bottom view
Rear View
Note: shown with optional wall mounting brackets (see Installation)
Keypad installation
See the techbook for your specific keypad model for installation details and drilling temperature.
Connecting the Main keypad to the spa pack
To connect the keypad, remove the cover, then insert the in.link connector into the appropriate keypad connector (as illustrated). Route the cable through one of the molded strain relief channels on the bottom right side of the spa pack (as illustrated). Fill the remaining space with the foam gaskets supplied. Don’t forget to replace the cover and all screws (torque to 8 in.lb max [0.9N.m]).
Note: always shut power down before connecting an accessory to the in.ye
Keypad
Connect the Main Keypad as indicated here.