93. Program Filtration & Onzen Settings - Arctic Spas

1.11.6 Program Filtration & Onzen Settings

The Onzen Chlorine Production (Onzen Cycle Duration) settings need to be programmed: The following steps provide guidance on how to program the Onzen system settings:

Steps to help Set Filtration & Onzen Settings

Step 1. Enter Filtration Options Through Topside Controller

Press the Filter button (pump 5 on epics) to enter into your filtration options. Your display will show “SETT” and from here you will be able to choose your settings.

Step 2. Ozone Cycle Duration Through Topside Controller

Press your Filter/Pump 5 button again to display your first option. This is your Ozone Cycle Duration.

* Peak II only, if Peak 1 is installed ozone will run during filtration.

Step 3. Setting Ozone Duration Through Topside Controller

Use your arrow keys o select your Ozone Cycle Duration. You can select from 1 to 24 hours per day.

Step 4. Enter Onzen Settings Through Topside Controller

Press your Filter/Pump 5 button again until you see 0n02.

Your display will now show the settings for your Onzen system.

Step 5. Onzen Cycle Duration

Use your arrow keys to select your Onzen Cycle Duration.
You can select from 1 to 24 hours per day.

* Cycles are divided into 4 ie: If 8 hours is selected, the system will perform 4 x 2 hour cycles per day.”

Step 6. Filter Duration

 

Press your Filter/Pump 5 button again.
Your display will now show the settings for your Filter Duration.

Step 7. Setting Filter Duration

Use your arrow keys to select your Filter Duration in hours.

You can select from 0 to 6 hours, the number of hours your filtration will run each time.

Step 8. Filter Cycle Frequency

Press your Filter/Pump 5 button again.
Your display will now show the settings for your Filter Cycle
Frequency.

Step 9. Setting Filter Cycle Frequency

Use your arrow keys to select your Filter Cycle Frequency

You can select from 1 to 4 times per day.
You can move backwards through the settings by pressing the Pump 3 button (Pump 4 on Epic series spas). The Pump 1 button will allow you to exit without saving any changes. When you get to the end of the options, press the filter key one last time to save changes and begin a filter cycle immediately. If you do not press the filter key again your changes will be saved and the filter cycle will begin when you have programmed it to do so.

* Press your Filter/Pump 5 button again to start the next cycles immediately (Pumps will purge for 20 seconds).
To EXIT without saving changes press Pump 1.
To SAVE & EXIT but not start the cycle simply let the display time out.”