43. Low Level Programming Overview - Arctic Spas

The following steps show how to access Low Level Programming (LLP) through your Spas Topside Controller to ensure your Spas IP Address is set to Dynamic (dy) and your Spa has been assigned a valid IP Address.

Step 1. Access Low Level Programming through your Topside Controller
Press and hold down the FILTER button until LLP is displayed in the display window (approx. 20 Seconds. The display with first show Filter settings Sett, continue to hold button down until LLP is displayed.
Note: For a 5 pump spa (Epic) press and hold down PUMP 5 button.

Step 2. Scroll through LLP Settings until IP is Displayed
Scroll through the LLP settings by pressing then removing your finger from the FILTER button until IP is displayed, IPst or IPdy will be displayed.

To change to IPdy press the Up Arrow button on the Topside Controller. Version 1 Revision Draft 1 onSpa and Web Connect User Guide
Issued Mar 2016 Page 13 of 24

Refer Section 1.10 onSpa Quick Reference Charts (QRC)
• Section: 1.9.1 onSpa QRC Through Ethernet Over Power (EoP) Flowchart.
• Section 1.9.2 onSpa QRC Through WIFI Extender Flowchart.
• Section 1.9.3 onSpa QRC Through LAN Cable Flowchart.

Step 3. Scroll to next LLP Setting to view the Spas IP Address Assigned as Displayed on the Topside Controller.

Scroll to the next LLP setting by pressing the FILTER button to display the IP Address assigned to the Spa.
Note: .0 or .100 may not be a valid IP Address.

Step 4. Scroll to the end of the LLP Settings to save/exit the settings.
Scroll to the end of LLP setting by pressing the FILTER button until you reach the end of the LLP settings. The Spa will then perform a reboot.

Step 5. Turn off the Electrical Power to the Spa. Turn of the power to your spa at the spas breaker.

Step 6. Turn on Electrical Power to the Spa. Turn on the power to your spa at the spas breaker.
Wait until the spa reboots fully.

Step 8. Scroll to the end of LLP Settings to save/exit the settings.
Scroll to the end of the LLP setting by pressing the FILTER button until you reach the end of the LLP settings. The Spa will then perform a reboot.